The problem of the paste filling machine not discharging the material during filling

It is crucial for each device to successfully complete work production. The most important steps in the production of paste filling machines are cutting and filling. If the equipment cannot discharge during operation, the entire production will not continue. Delaying production plans will cause significant losses to the enterprise. What should we do when the paste Filling Machine does not discharge?

Troubleshooting

1.Firstly, check if there is any product in the hopper. If there are no products, please add them. Attention: The product in the hopper cannot be less than 1/10. If it is less than 1/10, it will affect the filling accuracy.

2.Check if the filling tank of the filling machine is blocked. There are two types of blockages: first, due to the machine not being cleaned after a long period of filling, the products in the tank are frozen and blocked; Secondly, there are debris inside the product that gets stuck on the inner piston, resulting in poor sealing effect. If the above two situations occur, please clean it in a timely manner to avoid damaging the piston.

3.Neither of the above situations can solve the problem, that is, the sealing ring on the inner piston is damaged. Please replace it. The part below the hopper that delivers the product to the filling nozzle is called the lining.

Operating instructions

1.Before use, clean the hopper and add the product (i.e. the paste liquid that needs to be filled).

2.After adding the product, manually press the manual control lever until the product can come out of the filling nozzle normally.

3.After the product comes out normally, adjust the filling amount. There is a plastic nut under the hopper. Turning clockwise can reduce the amount of filling, otherwise it will increase. After adjusting to the required filling amount, work can begin.